I was considering just dropping it--the antenna & rotor are junk--but I don't want to bend the tower. From Business: TV Antenna Sales, Service & Installations. This then slid off the antenna mast and fell- with meon it. Assuming it falls straight, it will be parallel to the house with about 2' clearance. * Get help with antenna removal, including all types of repairs and installations Any ideas? If you have above ground wiring coming in, it may be down low where it enters your service box. So could I just cut off the bolt holding it upright and let it free fall with the pivot? House TV Antenna Removal | Techwalla +'::'+invisible+'::'+rn+"::"+escape(base.URL); WebWe also do over-the-air digital television (TV) antenna installation, upgrades and repair in central and southern Delaware and nearby. Pull the antenna over until it (gently) rests on the roof. I would carefully cut it, then lower Universal Towers : Now Available: Tech Talk Podcast with Scott Wilkinson, Episode 19 Click here for details. It is large and awkward,so you may want assistance, but it is quite light, especially if there is no "rotator". A hinge bracket at the bottom rocks all. We welcome your comments and WebIf it is a Ham radio antenna, contact the local HAM Club and tell them there is a free tower for the taking and they remove it. Hit the bare wires while grounded and you too may find out if there is an afterlife. Get access to broadcast TV and wireless internet. Copyright 2013-2022 - TV Antenna Man. By using the G-Series tower as a self-supporting tower, you minimize land area usage. His book, "Going for the Green: An Insider's Guide to Raising Money With Charity Golf," was published in 2008. WebPrice when purchased online. This is located in Carbondale, Illinois 62901. You're new in the neighborhood: maybe the cable situation isn'tall that great. The> antenna was totaled, however, and Dad's friend had to make do with a> different solution.>, Great story.